MAS Low Viscosity Epoxy Resin

This is the low viscosity resin that is used with any of the hardeners listed below. The resin to hardener ratio is always 2 to 1. The hardeners can be blended to modify your cure times depending on your work shop temperature and your time frame requirements

Please Note: All epoxy and varnish must be shipped through UPS. For an accurate estimate, please select UPS on the shipping screen.

MAS Slow Hardener

This No Blush hardener works well in a temperature range of 70 to 90 degrees. At 70 degrees you will have a 24-36 hour green cure stage. The next coat will chemically bond to the uncured epoxy. When we are working at our winter time 60 degree shop we normally blend this slow hardener with 25% fast hardener to end up with the same 24 hour green cure time. As long as we don't go beyond 30% fast hardener on the hardener side of the equation we won't have to worry about amine blush. Remember, the resin to hardener ratio is always 2 to 1.

Please Note: All epoxy and varnish must be shipped through UPS. For an accurate estimate, please select UPS on the shipping screen.

MAS Fast Hardener

As stated above you can blend this with the slow hardener to customize your cure times. If you use more than 30% fast hardener on the hardener side of the equation you will have to be aware of the possibility of amine blush.

Please Note: All epoxy and varnish must be shipped through UPS. For an accurate estimate, please select UPS on the shipping screen.